State |
Cause |
Solution |
All LED indicators are OFF after power supply is connected |
The power line is not operational |
Check the voltage of the power line connected to Nayar Switch |
|
|
In case of using the 12V Output of the GSR, verify that GSR is powered on |
|
Wiring of DC connector is incorrect |
Check the wiring of the DC connector |
Internet connectivity LED is not lit up (Machine room Nayar Switch) |
GSR is not providing Internet connectivity |
Check that GSR is powered on |
|
|
Confirm RJ45 cable is on LAN connector |
|
RJ45 cable is not working correctly |
Substitute RJ45 cable |
Internet connectivity LED is not lit up (Lift car Nayar Switch) |
Microswitch configuration is incorrect |
Verify that the configuration of bus termination resistors at 3.3.- Configuration of bus termination resistors |
|
IPBUS wiring is incorrect |
Check IPBUS wiring from installation schematic shown at 3.3.- Configuration of bus termination resistors |