Switch

3.1. Nayar Switch installation at the machine room

  1. Place the device close to the GSR, so as to be easily accessible to all the connectors of the Nayar Switch by the installer.
  2. Connect the RJ45 cable from the LAN connector of the GSR to the LAN connector of the Nayar Switch.
  3. Connect two unused wires of the travelling cable to the IPBus connector of the Nayar Switch.
  4. Connect the power supply cables to the VIN connector by means of the DC power connector. The polarity of the DC connector must be respected. (In order to supply power to the Nayar Switch, GSR 12V output may be used).
  5. Check whether the power and Internet connectivity LEDs are lit up.