Plug the Fridge-tag into any computer via USB interface. Make sure the device is plugged in properly.
Note: Disconnect the external sensor from the device first.
The Fridge-tag will now generate a PDF and ASCII report of the last 28, 56, 84 or 112 days (factory setting). Depending on the configuration, this process may take up to 2 minutes. Now choose the appropriate file generated by the Fridge-tag.
USB connection of the Fridge-tag
The continuously appearing arrows in the upper display area indicate that the device is operating.
Note: This process must not be interrupted until the OK symbol appears on the display. This indicates that the creation of the ASCII and PDF files has been successfully completed.
The hard drive of the Fridge-tag is shown in your explorer. Open the desired file generated by the device.
Note: To disconnect the device properly, please always use the function “Safely Remove Hardware” on your PC/Mac.
 |
Right-click the icon “Safely Remove Hardware and Eject Media” in the Windows taskbar (lower right corner). Choose the corresponding device to remove. |
 |
Do not disconnect the device before you receive the depitcted message, otherwise the device can be damaged. |
Note: For this process no additional software is necessary.
