The Run/Reverse inputs on all EZ-QUBE modules (EXCEPT EZ-QUBE-P-J Article Number 1510-6040) can be wired to accept either PNP or NPN source signals.
*The PNP and NPN versions of EZ-QUBE refer to how the ERROR and SPEED OUTPUTS are electrically configured at the factory. NPN or PNP EZ-QUBE part number designations do not apply to the signal source for the Run/Reverse inputs.
Single Module Wiring (all models EXCEPT EZ-QUBE-P-J Article Number 1510-6040)
![]()
![]()
Wiring Multiple Modules in Parallel (all models EXCEPT EZ-QUBE-P-J Article Number 1510-6040)
![]()
![]()
Single Module Wiring for EZ-QUBE-P-J (Article Number 1510-6040)
![]()
Wiring Multiple Modules in Parallel for EZ-QUBE-P-J (Article Number 1510-6040)
![]()
!To use the REVERSE input, either RUN A or RUN B must also be energized. Please note that you DO NOT have to de-energize both RUN A and RUN B signals in order to change MDR direction with the REVERSE input.