Agitation Level
It is necessary to consider build material when choosing agitation level for the VORSA 500, The chart featured below outlines what agitation level corresponds to which build material.
| AGA | Pump Speeds % | Temp F° | Material |
|---|---|---|---|
| 1 | 80 | 130 | Thin walled Nylon 6*, Nylon 12, Nylon 12CF |
| 2 | 80 | 140 | Normal Mode Nylon 6*, Nylon 12, Nylon 12CF |
| 3 | 80 | 150 | Brick Mode Nylon 6*, Nylon 12, Nylon 12CF |
| 4 | 80 | 160 | ABS-M30, ABS-M30i, ABS-ESD7, ASA, ABSi, PC, PC-ABS |
*Very fine elements (.04”/1mm) may warp during processing.
Duration
The thickness of support material will determine the length of cycle. Always ensure you are pointing supported areas towards the top and bottom sprayers and using flex nozzles to target any internal geometries.
Post your comment on this topic.