The VORSA 500 is designed to be fully automatic and configured to remove supports from FDM. The VORSA 500 is engineered to utilize an automated Volume Velocity Dispersion system, that is configurable based on a specific operational need. Our technology utilizes high volume and flow jet streams by spraying bi-directionally for mechanically assisted support removal.
The top of the VORSA 500 has a door which allows access to the process chamber. The process envelope is 16” x 16” x 14.5” (42 cm x 42 cm x 37 cm) where the part is exposed to a combination of chemical detergent through a high volume, low-pressure agitation algorithm to optimize a specific post-printing need. To release the chamber door, pull up on the paddle actuator located under the chamber door handles. The chamber door utilizes an air-spring system to ease opening and will support the door when fully open. Reminder, caution should always be used when reaching into the chamber.
 Wear laboratory- style protective glasses. |
 When working detergents, always wear protective gloves. |
 When working detergents, always wear a lab coat. |
If the HMI touchscreen is off, press the POWER button to turn on the VORSA 500 and wait for the Home screen to display.
 |
| Main Menu |
To begin a cycle, access the Auto Setup screen (below) by pressing the Automated button from the Home screen. It is important to note that the VORSA 500 will retain the settings from the previous cycle. If no changes are required, the cycle can be started by pressing the PLAY button. If new settings are required for the next cycle, review the procedures in the Auto Setup Controls section.
 |
| Auto Setup screen |
Post your comment on this topic.