The VORSA 500 is delivered with an industrial power cord. Use only the power cord supplied by PostProcess with the VORSA 500. Based on the model number of the machine, connect the VORSA 500 only to the power indicated in the table below.
| SR011 | UL/CSA, North America | CE |
|---|---|---|
| MODEL | -01 | -02 |
| PHASE | 3 | 3 |
| VOLTAGE | 240 | 400 |
| FREQUENCY | 60 | 50 |
| AMPERAGE | 30 | 25 |
Do not place the power cord in a location where it could come into contact with water or other liquid substances. It is recommended to keep the entire power cord suspended above the floor surface.
The VORSA 500 utilizes power provided through an industrial power cable/connector located on the upper-right rear of the unit when facing the rear of the machine, as shown in the images below.
 |
 |
| Power Cord Location | Power Connector |
The MASTER DISCONNECT SWITCH is located on the left access panel of the VORSA 500. Before connecting or disconnecting the VORSA 500 to power, ensure the MASTER DISCONNECT SWITCH is in the horizontal “O” or OFF position.
When the power cord is connected to the VORSA 500 and plugged into a specified power outlet, turn the POWER switch 90 degrees clockwise to the vertical “I” or ON position. The VORSA 500 is now ready to be powered up.
 |
 |
 |
The MASTER DISCONNECT SWITCH is located on the left access panel, shown above. To turn OFF the MASTER DISCONNECT SWITCH, grasp the switch and rotate counter-clockwise 90˚ to OFF. |
Post your comment on this topic.