Otros productos Nayar

1.3.2.3. Lift car/s configuration (BVA 12 relays)

  1. Click on the lift car device and adjust the relays and stops depending on how they are going to be connected. In this example, relays 1, 2 and 3 have been used for Ground Floor, Floor 1 and Floor 2, respectively.

    Pressing on Check the connections, it is possible to observe an example of the connection of the buttons and relays.
  2. From this step, it is compulsory to use the Nayar Systems App. Press the LINK button. The device that is desired to link must be located near the Smartphone used for configuration.

    There are two possibilities to link the device:
    • Click on the ID of the device (see previous image) which corresponds to the device to configure.
    • Click on the Discover button of the device to link.
      If the device has not been configured before, it would be necessary to wait for 10 seconds until it is configured, otherwise an alert message will be shown: “The lift car’s device is configured”.
  3. Repeat the process on every lift car’s device remaining.