COMPONENTS
A. All in One 10E
B. Antenna GSM (Optional)
C. Wireless USB Adapter (Optional)
D. USB Extender cable
E. 12VDC power adapter (Optional)
F. Die cut
CONNECTORS DIAGRAM
INSTALLATION
1. Use the die included in the box to mark the anchor points necessary for the installation of the Advertisim.
2. Remove the die, drill the surface based on the marks drawn in the previous step. Drill a central through hole, as shown in the explanatory drawing, large enough to pass the antenna cable and the 12VDC power cable of the Advertisim.
3. Place the antenna (if supplied) on the outside of the cabin (roof recommended), in order to improve signal reception. Connect the Wireless USB adapter (if supplied) (8) with its USB extension cable and antenna (9). Connect the Wireless USB adapter (if supplied) (8) with its USB extension cable and antenna (9).
4. Make the connections to the control panel.
5. Insert the display pins into the drilled holes.
6. Plug the adapter into a mains socket (1) and connect it to the Advertisim.
7. Configure the device using the Manager.
