Mast Setup And Takedown

Sedan

Mast Setup Procedure

1. Unlock the mast from the kickstand by removing the locking pin.
2. Lower and stow the kickstand.
3. Guide the mast upward until it is perpendicular to the hardtop.
4. Insert and screw the two port and starboard support screws at the bases of the mast (one for each side).

Mast Takedown Procedure

1. Detach the two port and starboard support screws at the bases of the mast (one on each side).
2. Guide the mast downward until it is lying parallel to the hardtop.
3. At the front of the mast, raise the kickstand up from the hardtop and lower the mast onto the top of the kickstand.
4. Lock the mast and kickstand in place with the locking pin attached to the kickstand.

Command Bridge

Mast Setup Procedure

1. Unlock the mast from the kickstand by removing the locking pin.
2. Lower and stow the kickstand.
3. Guide the mast upward until it is perpendicular to the command bridge.
4. Insert and screw the two port and starboard support screws at the bases of the mast (one for each side).

Mast Takedown Procedure

1. Detach the two port and starboard support screws at the bases of the mast (one on each side).
2. Guide the mast downward until it is lying parallel to the command bridge.
3. At the front of the mast, raise the kickstand up from the command bridge and lower the mast onto the top of the kickstand.
4. Lock the mast and kickstand in place with the locking pin attached to the kickstand.