Results

The Decision phase of the Hard Code Literals stage will provide the number of custom objects with Hard Coded Literals from each system after running the programs everything should be in a complete or no conflict status.

Once the Decision programs have run from the Operation section it is time to view the results, go to the ‘Results’ drawer and select the ‘Hard Code Literal’.

The screen below shows the number of objects in each system and the number of hard code literal conflicts and their status after the decision programs have run.

The buttons on this screen operate by clicking the right hand down arrow details on what each button does are as below.

The ‘Update’ button allows the user to run the programs for this phase individually, however, it is recommended the user does not use this and completes this through the operation drawer as this adds greater clarity.

The ‘Decision’ button allows the user to change the decisions, options are as below:

*Translate the literal
*Ignore Conflict
*Remediate Manually
*Cancel decision

The ‘Mass Decision’ button allows the user to run the programs for this phase, however, it is recommended the user does not use this and completes this through the operation drawer as this adds greater clarity.

The ‘Workflow’ button allows the user to open and close this phase.

The ‘Overview’ button allows the user to view the reports for this phase, see the Reporting section for more details.

On the hard code literals screen below, opening up an Object Type provides further folders where you can view more information about the objects in each object type. Opening up the ‘All Literals’ folders lists all of the objects of this type in both systems, opening up the ‘All Conflicting Literals’ folders lists all of the objects in the selected object type in conflict across the two systems. Here opening up the object and viewing the literal types will give you a view of these hard coded literals.

The details below reflect the literals details and the new value.

• Object Names
• Reference
• Data Element
• New value
  

If you right mouse click on the object name then the ‘Display’ option allows viewing the object in the system where the object resides.

Below if you right mouse click on the object name then the ‘Decide’ option allows the user to change the decisions, options are as below, this is the same as the ‘Decision’ button .

*Translate the literal
*Ignore Conflict
*Remediate Manually
*Cancel decision

*To keep the phases in order once you close a phase it cannot be reopened

When you are certain you are ready to close the phase use the option on the ‘Workflow’ button and select close phase. Continue to the next phase Execution Phase.