What to do if things go wrong - ConveyLinx-ECO Complete Guide

Module Status LEDs Blinking Green with unexpected results

Check that all sensors are operational and that all zones are clear then perform procedure again. How to change block/clear sensor logic without having to perform another Auto-Configuration
Check all network and power connections and make sure there is 24V on each ConveyLinx-ECO then try the Auto-Configuration procedure again
Verify that all of the module sensor/motor combinations are valid. Check here to find out what module set-ups will generate errors

Module Status LED is Blinking or Flashing Red

Make sure there are no other Ethernet devices (PC’s, Switches, Scanners, etc.) connected between any of the module on your network. The Auto-Configuration procedure aborts when it encounters a non ConveyLinx device along the network path before reaching the last module. ConveyLinx-ECOs up to that point should be configured properly but the remaining modules will not.
When removing a ConveyLinx-ECO from an existing configured network that is already operational; be sure to wait 1 or 2 minutes to allow the Ethernet Switches on the modules to reset their MAC Address ARP table before attempting a new Auto-Configuration procedure

フィードバック