|
The buttons on the right of the screen control access to basic navigation features.
- HOME – returns to the Home Screen.
- INFO – for current cycle operational data.
- SETTINGS – for basic system settings.
- ALERTS – displays Alarm conditions.
|
There are two primary settings that can be selected on the Auto Setup screen. The settings chosen for a specific cycle is based on the media selection and desired surface finish.
AGITATION LEVEL |
Settings 1 through 4 that control the detergent dosing frequency. |
|
Select the dosing frequency to optimize media performance. |
TIME |
This setting determines the cycle run time. |
|
Use the + and – buttons to increase or decrease the cycle time in 10 minute increments. |
The user is informed of the remaining capacity of both the supply and sediment tanks.
SUPPLY TANK LEVEL |
This displays the real-time output from the supply tank level sensor. |
|
The supply tank level will limit the maximum allowable continuous cycle time. |
SEDIMENT TANK LEVEL |
This displays the real-time output from the the sediment tank level sensor. |
|
Depending on the drain mode selected, the sediment tank level will limit the maximum allowable continuous cycle time. |
*If the user increases the maximum amount of recommended cycle time, a notification will appear that the supply tank will need to be filled.
|
Increasing cycle time beyond system recommendation. |
After adjusting the settings for the part to be finished, use the buttons shown below to control the cycle.
|
Press PLAY to initiate or resume a cycle. |
|
Press PAUSE to temporarily suspend processing while maintaining cycle time progress. |
|
Press STOP to end processing and reset cycle time. |
*A PostProcess Application Engineer will discuss the optimal settings for your application during the initial setup.
Post your comment on this topic.