 |
The buttons on the right of the screen control access to basic navigation features.
|
There are three primary variables that can be selected in the Auto Setup screen. The settings are based on the properties of the parts being finished.
| AGITATION LEVEL | Settings 1 through 4 that control the energy level intensity. |
 |
A key energy source is pressure. Selecting Level 1 will provide the lowest pressure and overall agitation, and Level 4 provides the most. |
| TEMPERATURE | The system will heat up to and maintain this temperature throughout part processing. |
 |
Use the slider to set the desired temperature of the detergent in the tank. The user can also use the + / – to adjust the temperature. |
| TIME | Part processing will automatically stop once the cycle time expires |
 |
Use the + and – buttons to increase or decrease the cycle time. |
In Auto Mode, the top spray rack on the BASE moves back and forth to create a sweeping motion for full tray coverage and improved agitation.
If the entire tray does not need coverage, these motion boundaries can be modified.
 |
The current setting, ‘Full Range’ is displayed. Press the blue OPTIONS button to adjust this setting. |
 |
Press the MOTION DISTANCE button to toggle between Full Range and Limit Travel options. Adjust the sliders to control how far back and forward the top spray rack travels during processing. |
Once the desired settings have been selected, the user has the option to start the cycle, save the settings, or open an existing set of processing parameters.
 |
After adjusting the settings, press the PLAY button to initiate or resume a paused cycle. |
 |
Press SELECT RECIPE to recall previously saved settings. |
 |
Press SAVE to store current settings for future use. See Recipe Management for more information. |
Hinterlasse einen Kommentar.