Activation of a Q-tag CLm doc family device

Q-tag CLm doc devices can be started as follows:

Q-tag CLm doc L	To initiate a shipment, press and hold the START/ STOP button until the display starts up. Active recording is shown by the (OK symbol) or (ALARM symbol) and the flashing dot on the LCD.
Q-tag CLm doc D & CLm doc Ice	To initiate a shipment, press and hold the START/ STOP button until the display starts up. Active recording is shown by the (OK symbol) or (ALARM symbol) and the flashing dot on the LCD.
Q-tag CLm doc	To initiate a shipment, break the respective tab. Active recording is shown by the (OK symbol) or (ALARM symbol) and the flashing dot on the LCD.
Q-tag CLm doc LR & CLm doc Ice R	Option 1: To initiate a shipment, press and hold the START/STOP button until the display starts up. Option 2: After reactivation with the software easy go and disconnecting the device from the USB interface Option 3: After preconfigured autostart date and time Important: Before reactivation of a Q-tag CLm doc LR or Q-tag CLm doc Ice R device you must connect the device to a USB port, please read out the recorded data, otherwise the recorded data will be lost! Active recording is shown by the (OK symbol) or (ALARM symbol) and the flashing dot on the LCD.

Expiry date: Please always verify the expiry date prior to using any device.
Expiry date explanation: Example exp 2020-01: In this example the expiry date of the device is January 2020 or 365 days after first use.

Q-tag easy go software

Reconfiguration and backup
The Q-tag easy go software is used to activate and reconfigure Q-tag CLm doc LR and Q-tag CLm doc Ice R devices as well as to safeguard the collected data.

Contact us to get the software: info@berlinger.com
More information: www.berlinger.com/easygo