Important Information

Liability

The manufacturer shall not be held liable:

• if the device was used beyond the manufacturer’s given limitations.
• for any claims due to the improper storage and use of the device.
• for any problems with the temperature controlling and/or cooling unit.
• for the bad quality of any monitored goods.
• for incorrect readings if the device was used beyond its expiry date.
  

Battery

The devices of the Q-tag CLm doc family contain a lithium battery. Please pay strict attention to the following points:

• The housing of a Q-tag CLm doc family device must never be opened nor destroyed.
• Do never expose a device of the Q-tag CLm doc family to temperatures above the allowed range (fire, oven, microwaves, etc.). It may cause injuries.
• Always keep a device from the Q-tag CLm doc family out of the reach of children.
• The battery complies with IATA DGR Packaging Instruction 970 Section II and is therefore not considered as dangerous good.
• Dispose or recycle the device from the Q-tag CLm doc family in accordance with the WEEE 2012/19/EU guidelines or your local regulations. The device may also be returned to the manufacturer for proper recycling.
• The end of the battery life is indicated by the expiry date printed on the label. Accuracy and proper function of the device cannot be assured beyond this date.
  

Useful life

• The devices can be used XXX days, but not longer than 365 days. It depends on the device type (see technical specifications) and on the condition that:
• The buttons are not pressed for a very long time, e.g. if jammed between the goods in a shipment.
• Storage and operation of the device should remain inside the recommendations of the manufacturer, especially temperatures below 0°C or 32°F could have a negative influence on the operating lifetime of the battery.

Attention

All devices of the Q-tag CLm doc family monitor temperature exposures and not the product quality. Its purpose is to signal if product quality evaluation or testing is required.

Subject to change. Please note that all information in this document is correct at the time of publication. Due to our policy of continuous product development, we reserve the right to change this information without prior notice.

Regulatory certification

Manufactured by:

Berlinger & Co. AG Mitteldorfstrasse 2 9608 Ganterschwil SWITZERLAND