![]() |
Wire terminals on all removable connectors are “cage-clamp” style requiring a small blade screwdriver to open the clamp to insert the wire |
![]() |
| I/O Connector Plug |
| Part Number |
Degson 8EDGK-2.5-07P-11 |
| Wire Size |
28 – 20 AWG (0.2 – 0.5 mm 2) |
| Strip Length |
5 – 6 mm |
| Pin |
Signal |
Direction |
Description |
| 1 |
0-10V |
Input |
0-10 Volt analog input for speed control |
| 2 |
Speed |
Output |
Outputs frequency proportional to the speed of the MDR |
| 3 |
Error |
Output |
Provides +24V or 0V output when Error condition is active |
| 4 |
Reverse |
Input |
Accepts +24V or 0V input to run motor in opposite direction that is set on DIP Switch “CONFIG”-2 |
| 5 |
Run A |
Input |
Accepts +24V or 0V input for run at speed control (see section Run A and Run B Inputs) |
| 6 |
Run B |
Input |
Accepts +24V or 0V input for run at speed control (see section Run A and Run B Inputs) |
| 7 |
Common |
PNP Versions |
DC common for optocouplers of Inputs (Run A, Run B, Reverse) |
| NPN Versions |
+24V common for optocouplers of Inputs (Run A, Run B, Reverse) |
!For EZ-QUBE-P-J (Article Number 1510-6040), the COMMON terminal is internally connected to the module’s 0v DC Common. All other PNP versions require a 0V DC Common connection to COMMON terminal. NPN version requires +24V connection to COMMON terminal.
