Input / Output Signal Settings - EZ-Qube Reference Manual

	Select whether you want the Speed output to be a PNP or NPN signal. Refer to Speed Out Topic for wiring details.
	Select whether you want the Error output to be a PNP or NPN signal. Refer to Error Out Topic for wiring details.
	Select if you want to use the Analog input to control speed or use the Speed Settings from the app. Refer to 0-10 Analog Input Topic and Run/Reverse Inputs Topic for wiring details.
	Select Use Common if you want to isolate the Run/Reverse inputs from the module power supply. Note that if you select Use Common , the PNP / NPN Inputs selection for are ignored. Refer to Run/Reverse Inputs Topic for wiring details.
	Use this selection when you deselect Use Common from item . The Common terminal on the module will be ignored and this PNP or NPN selection will determine your wiring method and will utilize the module’s power supply for reference voltage and GND. Refer to Run/Reverse Inputs Topic for wiring details.
	Select if you want the Error signal to be ON or OFF when an error condition is active.
	Select if you want errors to automatically clear. If unchecked, you will have to either cycle the Run OFF then ON or cycle the module power OFF then ON depending on the error.

6.3. Input / Output Signal Settings