The DEMI 930 is designed to be fully automatic and configured to remove excess resin from Carbon print technologies. The DEMI 930 is engineered to utilize an automated Submersed Vortex Cavitation system that is configurable based on a specific operational need.
The top side of the DEMI 930 houses the main processing tank. The part envelope is approximately 46 cm x 46 cm x 46 cm (18” x 18” x 18”) and is filled with detergent carefully selected to maximize a specific support removal need. When fully opened, the hinged doors will remain supported by the top platform to guide detergent back into the tank. Caution should be used when reaching into the tank.
To the left of the processing tank is the overflow tank where an operator can access the screen filter. For more information about cleaning and maintaining the filtration system for the DEMI 930 please see the Maintenance Operations section of this User Manual.
If the controller touchscreen is off, press the POWER button to turn on the DEMI 930 and wait for the Home screen to display.
 |
| Home screen |
To begin a cycle, access the Auto Setup screen (below) by pressing the AUTOMAT3D™ button from the Home screen. It is important to note that the DEMI 930 will retain the settings from the previous cycle. If no changes are required, the cycle can be started by pressing the PLAY button. If new settings are required for the next cycle, review the procedures in the Auto Setup Controls section.
The Cycle Time will be displayed in minutes and seconds (MM:SS) as shown below.
 |
| Auto Setup screen |
Post your comment on this topic.