ATevo chargers equipped with an Ethernet Communications Adapter and running Firmware v3.3.0 or higher provide an additional feature called the Web Server. This feature allows configuration of the charger using a standard web browser.
The Web Server can be be enabled or disabled with a hardware jumper located at P6 on the Main Control Board (A1). The ATevo ships from the factory with the Web Server disabled and a hardware jumper in the storage position at pins 2 and 3 of P6.
To enable the Web Server feature:
Connect pins 1 and 2 of P6 with the provided jumper.
Additional configuration of the Web Server may be required. See the following 2 sections:
- Section 4.2.7 Configuring Web Server Ethernet Parameters
- Section 4.3 Web Server Configuration
To disable the Web Server feature:
Remove the jumper from pins 1 and 2 of P6 and optionally return it to the storage position at pins 2 and 3 of P6.