V4 offers several hardware based video capture options to bring SDI, DVI and Display Port signals into Hippotizer systems. Capture cards are available fitted when the server is built, or can be fitted afterwards by a qualified technician. For Karst, Boreal and Taigas a capture card also requires new back plates which can be ordered from Green Hippo.
Note: Green Hippo strongly recommends sourcing cards from your local distributor to ensure compatibility. |
Capture Cards per system
Each model Hippotizer system supports different numbers of capture cards based on the space available:
Amba or Amba+
- 1 x Capture Card or Accessory Card
Note: Amba and Karst does not support Quad SDI or Dual Display Port capture Cards |
Karst or Karst+
- 1 x Capture Card or Accessory Card
Note: Amba and Karst does not support Quad SDI or Dual Display Port capture Cards |
Boreal or Boreal+
- 2 x Capture Cards
and
- 1 x Accessory Card
Taiga+
- 2 x Capture Cards
and
- 1 x Capture Card and 1 x Accesory Card
Taiga
- 2 x Capture Cards
or
- 1 x Capture Card and 1 x Accesory Card
Montane +
- 2 x Capture Cards
or
- 1 x Capture Card and 1 x Accesory Card
Supported Capture Cards
The following lists supported capture cards:
- Data Path VisionSDI2 — Dual 3G-SDI Capture
- Data Path VisionSC-SDI4 — Quad 3G-SDI Capture
- Data Path VisionSC-DP2 — Dual Display Port 1.2 Capture
- Data Path VisionAV-SDI — SDI, DVI and Composite Capture
- Data Path VisionRGB-E2S — Dual DVI Single Link Capture
Capture Drivers
Using the correct software driver for Hippotizer is critical to ensure proper functioning of the capture cards. Please refer to the release notes of the specific Hippotizer software version for guidance on which driver to use.
Note: The firmware of each capture card is updated during driver installation. For this reason it may be required to run the driver installation after a factory restore to ensure card firmware matches software. |
Hinterlasse einen Kommentar.