Important note for reading information from activated devices:
To avoid misreading the Q-tag CLm interrupts its recording if and as soon as the INFO-button is pressed (e.g. caused by hand temperature). Reading and recording will automatically resume after 14 minutes without any button pressing.
The chart below explains the information indicated on the LCD screen upon successive INFO-button pressing after activation or in STOP Mode:

Pressing the INFO-button Displayed information
1st Current time, date and ambient temperature
2nd Min. Temp. observed with time and date stamp of occurrence
3rd Max. Temp. observed with time and date stamp of occurrence
4th* Time and date of occurrence of 1st Single event alarm low, (SL, lowest alarm arrow)
5th* Time and date of occurrence of 2nd Single event alarm low, (SL, lowest alarm arrow)
6th* Total duration of temperature recorded in range Single event low, (SL, lowest alarm arrow)
7th* Total duration recorded in range cumulative low (AL, 2nd lowest alarm arrow); time and date of occurrence in case an alarm has been triggered
8th* Total duration recorded in range cumulative high 1 (AH1, middle alarm arrow); time and date of occurrence in case an alarm has been triggered
9th* Total duration recorded in range cumulative high 2 (AH2, 2nduppermost alarm arrow); time and date of occurrence in case an alarm has been triggered
10th* Time and date of occurrence of 1st Single event alarm high, (SH, uppermost alarm arrow)
11th* Time and date of occurrence of 2nd Single event alarm high, (SH, uppermost alarm arrow)
12th* Total duration recorded in range Single-event high, (SH, uppermost alarm arrow)
13th Start time and date (device activation)
14th Stop time and date (device deactivation)

*(only indicated if alarm limit preset and range violations occurred, otherwise skipped)

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.