Placing the Q-tag CLm

The activated monitor must be placed immediately in its predetermined location. It is recommended to place the device as close to the supervised goods as possible. This is an important prerequisite to ensure the temperatures observed by the device are as close to the product temperature as possible.

Note: It is recommended to “precondition” the device for about 30 minutes to the desired mean temperature before use, especially if no start delay time has been programmed. This is to insure against false readings during start up.

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.