SET/GET parameters are used to ensure that dialog transactions run in the playback are run in the same manner as they were captured in the recording. The users SET/GET parameters are captured at the start of the transaction only (not at each step) and restored during the playback just before triggering the transaction for hte user. Thus this linkage type acts as a service virtualization technique.

An example of the new investigate screen showing these SET/GET parameters is shown below.

Linkage Type - SET/GET Parameters

When the user clicks on the linkage, each of the SET/GET parameters that will be set during the playback are shown along with their associated values.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment