The inputs to the step, expected outputs and actual outputs are displayed at the top of the screen, as seen in the screen-shot below.

You are now able to change which of the 3 options are displayed and in what combination by clicking on the “Parameters” button.

  • None – No inputs/outputs are displayed at all
  • Inputs / Expected – Only the inputs and expected outputs are displayed
  • Inputs / Actual – Only the inputs and the actual outputs are displayed
  • Expected / Actual – No inputs are displayed and only the expected and actual outputs are shown
  • Inputs / Expected / Actual – This is the default setting and shows all 3 inputs/outputs


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment