In transaction SCI it is possible to setup Code Inspector variants to perform security checks on SAP programs. These can be setup as General variants for all users or user specific ones. Dev Enforcer: Security (0004) hooks into these variants to perform the check as part of the Analysis/Approval process within ActiveControl.
|CIEXCL_EXISTING_ISSUES|| Can be used to display the Code Inspector results in following modes:
LIST_ALL – All the CI issues that have been existing will be listed
LIST_BOTH_SEP – issues that have been existing and issues that are introduced with the current transport will be displayed with separate section.
LIST_NEW – Only issues that are introduced with the current transport will be displayed.
|IGNORE_WARNING_INFO|| EXCLUDE_BOTH: Exclude both Informational and Warning messages from DevEnforcer results. Only Errors will be reported.
EXCLUDE_INFO: Exclude only Informational messages. Warning and Error messages will be reported.
EXCLUDE_WARNING: Exclude only Warning messages. Information and Errors messages ill be reported.
|CISID||SAP System ID for Execution. Specify the system ID (e.g. D01) where the Code Inspector variant is to be run from.|
|CITARGET||Target System for Execution if CISID is not specified. Specify the target system ID (e.g. 0001) where the Code Inspector variant is to be run from.|
|CIUSER||Code Inspector Execution User. Leave blank for global variants.|
|CIVARIANT||Code Inspector Variant name.|