Site Preparation Requirements

Power and Electrical

The following is required from the customer:

*Ensure all electrical and hose connections terminate within close vicinity of the final machine location. PostProcess will connect the respective sources to the machine during installation.

Facility and Floor Requirements

Operating Environment Requirements:

• Temperature: 5°C to 40°C (41°F to 104 °F)
• Relative humidity: 0% to 80%.
• Maximum altitude: 10,000 feet (3,048 meters)
• Pollution Degree 2
• Overvoltage Category II
  

• Sufficiently sized doorways to transport the machine from loading dock to permanent installation location.

• Smooth, level flooring. The must be placed on a level floor.

• Sufficient space in installation location for and operator to maneuver around the machine and access master disconnect switch during normal operation.

• Locate and operate the unit at least 6 inches (0.15m) from any wall from all enclosure sides

• Installation area should be spacious and well ventilated.

• Power disconnects, plumbing, and emergency equipment should be installed in the same room as the .

Ventilation

PostProcess Technologies detergents are a specifically formulated chemistry for maximized 3D printed support removal efficiency. It is recommended that the equipment be located in a well-ventilated room. Specific ventilation requirements can vary widely due to size of the install room, existing ventilation (positive or negative) and differences in individual sensitivities to airborne scents or fragrances.

For more information on the safe use of PostProcess detergents refer to the SDS for the specific detergent used.