Power and Electrical
The following is required from the customer:
| SR006 | CE | UL/CSA North America |
UL/CSA North America |
|---|---|---|---|
| MODEL | -05, -08, -09, -11 | -06, -10 | -07, -12 |
| Power | 1 PH, 230VAC, 20A | 1 PH, 240VAC, 20A | 1 PH, 120VAC, 20A |
| Receptacle | Wall Mounted: ABB ABB332R6W |
Wall Mounted: ABB ABB332R6W |
NEMA L5-20R (L5, 20A, 120VAC, 2-POLE, 3-WIRE) |
Facility and Floor Requirements
Operating Environment Requirements:
- Temperature: 5°C to 40°C (41°F to 104 °F)
- Relative humidity: 0% to 80%.
- Maximum altitude: 10,000 feet (3,048 meters)
- Pollution Degree 2
- Overvoltage Category II
- Sufficiently sized doorways to transport the machine from loading dock to permanent installation location.
- Smooth, level flooring. The DEMI 800 Series must be placed on a level floor.
- Sufficient space in installation location for DEMI 800 Series and operator to maneuver around the machine and access master disconnect switch during normal operation.
- Locate and operate the unit at least 6 inches (0.15m) from any wall from all enclosure sides
- Installation area should be spacious and well ventilated.
- Power disconnects, plumbing, and emergency equipment should be installed in the same room as the DEMI 800 Series.
Ventilation
PostProcess Technologies detergents are a specifically formulated chemistry for maximized 3D printed support removal efficiency. It is recommended that the equipment be located in a well-ventilated room. Specific ventilation requirements can vary widely due to size of the install room, existing ventilation (positive or negative) and differences in individual sensitivities to airborne scents or fragrances.
For more information on the safe use of PostProcess detergents refer to the SDS for the specific detergent used.
Post your comment on this topic.