Press the orange SETTINGS button ![]()
along the right side of the touch screen to access additional operational features as described below.
*To restart the system, press the red RESET button on Page 1 of the Settings screen.
| AUTO-TEMPERATURE |
Enable this feature to maintain a set temperature between cycles. If AUTO-TEMPERATURE is not enabled, the DEMI 400 Series tank heater will need to be run manually to bring the temperature up to the desired level before starting the cycle.
To adjust the AUTO-TEMPERATURE SETPOINT and CHECK WAIT TIME, see page 2 of the Settings screen by pressing the BLUE ARROW (see below) |
| RESIN REMOVAL MODE |
When enabled, this mode changes processing parameters for optimum photopolymer resin removal. Overall cycle time is shorter, and cycle time resolution is finer. Some agitation technology may have its output scaled or turned off entirely. To switch to this mode, please contact a PostProcess Applications Engineer. |
To choose a different language or measurement system, see page 3 of the Settings screen (see below)
![]() |
| Settings – Page 3 |
along the right side of the touch screen to access additional operational features as described below.
Post your comment on this topic.