The Alarms Tab of PeteVision application shows System Alarms Detail / System Alarm History Detail data specific to the Admin User.
The Admin User is limited in the Application to Only:
- Acknowledge System Alarms,
- Clear System Alarms
System Alarms Detail
| ID | ID of the System Alarm |
| Severity | Severity level of the Alarm (Minor = Orange, Major = Red) |
| Equipment | Equipment ID attached to the Alarm |
| Description | Description of the Alarm |
| Date & Time | Date and Time in which the Alarm was raised |
| Acknowledge | Acknowledge Status, if clicked the User Credentials, Date and Time will show |
| Clear | Allow to Clear the Alarm in order to push the Alarm to Alarm History |
The System Alarms show the current Active System Alarms.
Admin user can Acknowledge and Clear Alarms by clicking the Switches to Yes.
Once done, a Message Appears at the top of the Page confirming the Action.
The column now reflects the User Name and Date of when the acknowledge event happened.
The Clear Switch is handled the same way as the Acknowledge switch.
Clearing the alarm, will Remove Alarm from the Grid making it available in the Alarms History Tab.
System Alarms History Detail
| ID | ID of the System Alarm |
| Severity | Severity level of the Alarm (Minor = Orange, Major = Red) |
| Equipment | Equipment ID attached to the Alarm |
| Description | Description of the Alarm |
| Date & Time | Date and Time in which the Alarm was raised |
| Acknowledged | User Credentials, Date and Time logged |
| Cleared | User Credentials, Date and Time logged |
The System Alarms History allows the Admin user to Review recently Acknowledged and Cleared System alarms.
Feedback
Post your comment on this topic.