Display Settings

4.2. Display Settings

1. To modify the Data Chart display settings, left-click on the Display tab located at the top-right corner of the screen:

a. You can choose which sensors’ data you can display or hide in the Sensor Selection checklist for both Processed Data (the default data displayed) or Raw Data. In this flow monitoring station all four sensors (Rainfall, Depth, Velocity and Flow) are currently displayed and there is no raw data for the sensors

b. Static Data lines can be added or removed from the checkbox to be seen on sensors if specific thresholds are identified, such as a pipe diameter for a depth sensor

c. Manual measurements can be added or removed from the Calibrated Data checkbox to visualize how the measurements taken in the field compare to the sensor data

d. Annotations can be seen by default over the sensors or hidden if the Display Annotations checkbox is unchecked. New annotations can be added by left-clicking the Add Annotation button and left-clicking again on the Data Chart sensor on the time range where you would like the annotation to be seen

e. To select a specific time range, go to the Time Range section, input a date and time to Start and End of the range and left-click the Show Range button. To see all data for all sensors in this flow monitoring station go to Show Entire Range

f. Precipitation and flow sensors can have their time Interval increased and decreased to display different volumes over minutes, hours, days, months, etc. The Flow Interval has been changed in the example below to 1 day and the flow values are calculated into a daily volume (in cubic meters):

2. To close the Display tab simply left-click the right-facing arrow on the top-left side of the tab: