8. Internal Jumper Settings

In some cases you can change the PNP/NPN operation of the SPEED and/or ERROR output signals by changing internal jumper settings on the EZ-Qube Module module’s circuit board

!CAUTION !!!! Modifying internal jumper settings involves removing the module’s plastic housing cover. Handling the EZ-Qube Module module without the cover must only be done by personnel who have been adequately electro-statically discharged. Handling the module with the housing cover removed without proper ESD precautions may result in module damage

On the PCB of the EZ-Qube Module there are three (3) jumpers:

ERROR Output States

Jumper Position		Module Version	When No Error is Active	When Error is Active
Err.Type	Error
		NPN	ON	OFF
		NPN	OFF	ON
		PNP	OFF	ON
		PNP	ON	OFF

SPEED Output

Jumper Position	SPEED Output
	NPN
	PNP

*Note that the SPEED Output jumper settings are the same for either PNP or NPN Module hardware versions