The is delivered with an industrial power cord. Use only the power cord supplied by PostProcess with the . Based on the model number of the machine, connect the only to the power indicated in the table below.
| CE | UL/CSA North America |
UL/CSA North America |
|
|---|---|---|---|
| MODEL | -05, -08, -09, -11 | -06, -10 | -07 |
| PHASE | |||
| VOLTAGE* | |||
| FREQUENCY | |||
| AMPERAGE |
*Overvoltage Category II
Do not place the power cord in a location where it could come into contact with water or other liquid substances. It is recommended to keep the entire power cord suspended above the floor surface.
The utilizes power provided through an industrial power cable/connector located on the lower-rear of the right-side panel as shown in the images below.
 |
 |
| Power cord location | Power connector |
The MASTER DISCONNECT SWITCH is located on the rear access panel of the . Before connecting or disconnecting the to power, ensure the MASTER DISCONNECT SWITCH is in the horizontal “O” or OFF position.
When the power cord is connected to the and plugged into a specified power outlet, turn the POWER switch 90 degrees clockwise to the vertical “I” or ON position. The is now ready to be powered up.
 |
 |
 |
The MASTER DISCONNECT SWITCH is located on the left access panel, shown above. To turn OFF the MASTER DISCONNECT SWITCH, grasp the switch and rotate counter-clockwise 90˚ to OFF. |
Ge din feedback på detta.