Power and Electrical

The following is required from the customer:

SR007 CE UL/CSA
North America
MODEL -02, -04 -03
Power 3 PH, 400VAC, 15A 3 PH, 208VAC, 30A
Receptacle Hubbell HBLS516R6W Hubbell HBLS532R9W
Connector Hubbell HBLS516C6W Hubbell HBLS532C9W
Housing Hubbell BB201W Hubbell BB2030N

Plumbing and Drainage

The DECI includes 3 plumbing ports on the back of the machine.

  • FILL: auto-fills the chamber with fresh water. This function will typically be used for cleaning the machine periodically.
  • DOSE: auto-doses the chamber with a ratio of water and detergent. The detergent is dosed into the machine via a DOSATRON® (included) manifold from 5-gallon buckets.
  • DRAIN: drains the chamber.
Example Dosatron Configuration

External Plumbing Requirements

Function Required from Customer
Dosatron inlet Municipal Water Supply
FILL inlet Municipal Water Supply
Connect a splitter to municipal water to supply both the Dosatron and FILL inlets
DRAIN outlet Floor Drain or Waste Container*

Facility and Floor Requirements

Operating Environment Requirements:

  • Temperature: 5°C to 40°C (41°F to 104 °F)
  • Relative humidity: 0% to 80%.
  • Maximum altitude: 10,000 feet (3,048 meters)
  • Pollution Degree 2
  • Overvoltage Category II
  • Sufficiently sized doorways to transport the machine from loading dock to permanent installation location.
  • Smooth, level flooring. The DECI must be placed on a level floor.
  • Sufficient space in installation location for DECI and operator to maneuver around the machine and access master disconnect switch during normal operation.
  • Locate and operate the unit at least 6 inches (0.15m) from any wall from all enclosure sides
  • Installation area should be spacious and well ventilated.
  • Power disconnects, plumbing, air, and emergency equipment should be installed in the same room as the DECI.

Ventilation

PostProcess Technologies detergents are specifically formulated for maximized 3D printed support removal efficiency. Specific ventilation requirements can vary widely due to the local, state, and federal regulations, size of the install room, and existing ventilation (positive or negative).

To meet safety and environmental requirements, it is recommended that the post printing operations using PostProcess equipment and chemistry solutions have ventilation that is exhausted externally. Our VVD and TAF solutions come equipped with ventilation systems (blowers) upon request. Our SVC solutions should be located in a well ventilated area and have a ventilation draw on the open top tank. Make up air should be provided from the facility where the equipment is located.

It is recommended that customers performing post printing operations have or consult with a responsible environmental health and safety person (such as an Industrial Hygienist) to determine and verify meeting environmental, health, and safety (EH&S) requirements.

PostProcess can provide the recommended ventilation requirements for each of our solutions as well as recommendations for ventilation consultation and EH&S / Industrial Hygienists.

The DECI is equipped with two ventilation ducts at the top rear of the machine. The customer is responsible for providing any ventilation ductwork if so desired. It is recommended that the equipment be located in a well-ventilated room. Connecting the blower exhaust to either a ductless hood with activated carbon filtration or a ducted system to remove the exhaust from the room is highly suggested.

For more information on the safe use of PostProcess detergents refer to the SDS for the specific detergent used.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
Your feedback will remain private. Click here to Request Technical Support.

Post Comment