Flex nozzles should be used to improve support removal rates on internal channels for a limited number of parts. You can install a maximum of 26 flex nozzles at once. For processing a higher volume of parts with complex geometries see the following section on the Submersion Vortex Cell.
INSTALLATION:

  • Remove the part tray from the chamber and set aside. You now have access to the bottom manifold.
  • Using an adjustable wrench remove the front left manifold nozzle.

  • The flex nozzle will thread into the open nozzle port. Tighten with the same adjustable wrench.
  • The flex nozzle kit comes with additional colored clamps that can be added around the joints for increased rigidity.
Manual Run Mode, Both Pumps and Bottom Spray Racks On
  • It is important to note that the flex nozzle will only be used while the bottom spray rack is on. When in use we recommend operating in Manual Mode. Additionally, you may contact PostProcess to change the back end settings of your Auto Mode.

USAGE:

  • Once installed replace the tray and angle nozzles toward internal geometries as seen in the following photo. Fixture bars and bolts can be used to keep the part in place.

Réaction

Était-ce utile?

Oui Non
Vous avez indiqué que ce sujet ne vous a pas été utile ...
Pouvez-vous SVP laisser un commentaire nous disant pourquoi? Merci!
Merci pour vos commentaires.

Laissez votre avis sur ce sujet.

SVP ne pas utiliser pour des questions de support technique.
Your feedback will remain private. Click here to Request Technical Support.

Valider