Prefer a Video?
In this clip, we show you how to enroll the SR3 Bluetooth Reader after you install it.
A technician on site must associate each reader with a system before mobile credentials can be purchased in Dealer Admin by an Administrator.
- Stand at the reader and ensure your device has Bluetooth turned on.
- Open Tech APP, then find and open the appropriate system.
- Tap the Bluetooth Readers tile.
- Tap
Add. Name the reader, then tap Create.
- When prompted, touch your device to the reader. When paired successfully, the reader beeps.
- In Tech APP, pull down the screen to refresh the reader list, then open the reader you created.
- Use the slider to adjust the Reader Range closer or farther as needed. Range is 3 in to 30 ft (7.62 cm to 9.14 m).
- To update the reader’s firmware, go to Firmware and tap Update. If no new firmware is available, this button is not displayed.
- Tap Save.
After being enrolled, the reader’s LED changes from steady yellow to steady white.
If you receive a message that states the 56-bit card format cannot be added, you must add the format manually in Full Programming > Device Setup > Card Formats:
Name | Wiegand Code Length | Site Code Position | Site Code Length | User Code Position | User Code Length | User Code Digits |
---|---|---|---|---|---|---|
BLUETOOTHFORMAT | 56 | 1 | 16 | 17 | 34 | 10 |
© Digital Monitoring Products, Inc.