The quick start guide is to be used after installation and includes the key basic steps required to create a recording and a playback. Please check the installation guide here if that process is not complete. It details the process steps required to allow you to use Testimony for a Regression test cycle. It assumes a reasonable level of knowledge of the Testimony architecture, as well as some knowledge of SAP systems architecture and SAP Basis.
Each section in the Quick Start Guide covers a separate step of the overall process. The steps should be followed in the order in which they are described.
- Test Plan and System Connections
A test plan must first be created and configured prior to any recordings being performed or playbacks.
- Performing a Recording
This is the process for activating and monitoring the recording on the source systems.
- Review Recordings/Send to Repository
Once recording is complete, you should review the recordings that have been captured and move them to the Testimony script repository.
- Performing a Playback
This is the process to prepare for, execute and monitor the playback of recorded activities on the target systems.
- Review Playback Results
The end result of the process which highlights discrepancies between what was recorded from the live system and what potential issues have been identified in the test system that is played back into.