2.3 Setting up Emergency Service

!This configuration is optional, Please setup your CER if you are planning to use Emergency Service in Console.

To setup CER in Call Manager please follow the instruction below.

Step 1 : Enable Emergency Call Handler

Step 2: Configure Emergency Location Groups

Step 3: Add a Device Pool to an Emergency Location Group

Step 4: (Optional) Add Device to an Emergency Location Group

Step 5: Enable Route Patterns and Translation Patterns

*for more information please follow the CISCO documentation

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/11_5_1/featureConfig/CUCM_BK_C7DC69D3_00_cucm-feature-configuration-guide_115/CUCM_BK_C7DC69D3_00_cucm-feature-configuration-guide_115_chapter_0110000.html

Copyright and Trademarks:

I. Copyright:

This website and its content is copyright © 2018 Akkadian, LLC. All rights reserved. Except with the prior written permission of Akkadian, LLC, any redistribution or reproduction of part or all of the contents of this website, including the redistribution or reproduction of any documentation or other materials downloaded from this website, in any form and in any media, is prohibited.

II. Trademarks:
Akkadian, the Akkadian logo and other trademark or service marks used on this website, whether registered or not, are the property of Akkadian, LLC and may not be used or reproduced without the prior written permission of Akkadian, LLC.

aPME UG 1/8/2018 0001 © http://www.akkadianlabs.com/apme/