6.5.5. Training section

In this section there are buttons responsible for the basic control of the training session.

When a training session is active, the caption of the “Training” section changes to light green.

Operation of the Tempo buttons:

• “1” – this button sets the pause value between spins at 2500 milliseconds – (2.5 seconds). With this delay, voice messages informing about the drawn number are active.
• “2” – this button sets the pause value between spins at 1500 milliseconds – (1.5 seconds). With this delay, voice messages informing about the drawn number are active.
• “3” – this button sets the pause value between spins at 250 milliseconds – (0.25 seconds). With this delay, voice messages informing about the drawn number are not active.
• “4” – this button sets the pause value between spins at 0 milliseconds – (0.0 seconds). With this delay, voice messages informing about the drawn number are not active. The speed of drawing spins in this mode depends on the speed of the computer, the number of graphs displayed and the data on them, etc.
• “Fx” – this button sets the value of the pause between spins to the value set by the user in the main platform settings. Each unit represents 10 milliseconds. By default, this value is set to 250, which means a 2.5 second pause between spins. The pause can be set from 250 – (2.5 seconds) to 10000 – (100 seconds). With a minimum delay of 250 or more, voice messages informing about the drawn number are active.

The selected mode is saved to the settings file and is activated each time the platform is started. An active pause mode changes the font color of its button to green.

!For the voice prompts to be active, you need to check in the main settings of the platform if the sounds for a specific session are also turned on.

*All buttons in this section apply to both the Random Number Generator based training session and the Session File based training session. The difference between the two modes is described in thread No. 6.2 Menu panel – (training, training “RNG”)

• “Start, Pause” – this button is to start and pause an active training session.
• “Stop” – with this button we can end the current training session. The finished session can be continued by selecting the training again in the menu panel. We will be asked whether to continue the session. When confirming, the session will start from the last spin of the previous session.