This button is used to start the procedure that sets the cursor return point. This is the point on the screen where the mouse cursor will return after finishing the work of the AutoMat module (after placing the numbers). When the point setting procedure is started, the font of the button responsible for it and the position panels on the right side of the button will flash in light green. To set the return point, you need to move the cursor over the point of interest on the screen and click the left mouse button. There are two additional icons on the button:
- a white square, after which the mouse cursor will be positioned at the point defined during the configuration procedure. By clicking the icon, we will check if the setting is in the right place.
- round in red or green. Click this icon to enable or disable the cursor return function. If the icon is red, the feature is disabled. If the icon is green, it means that the function is active.
Revision:
3
Post your comment on this topic.