The wire map sometimes shows that the customer’s location on the map is not accurate and the actual stop is grey point in the map and listed in the “Unpaired stop” table.
Then you can simply adjust location position according to reality.
Select a stop outside the plan on the schematic map (after clicking on the stop, a line with information about the stop will be highlighted in the table under the map) and an unvisited point, then click the “Geocode” button.
An additional window with a map will be opened, there you can confirm the changes simply by pressing the “OK” button.
On the map, the original location is marked with a red circle and the new location is marked with a black icon.
Post your comment on this topic.