Offset : By default this mode repeats the pattern across the ZLHoop. You can also set the pattern to show up only 3 times around the hoop and it will automatically center it leaving LEDS turned off between the patterns.
There are 4 Options here use the same Offset button to choose one of 4 options
Use the Arrows Left Right to offset the pattern on the hoop.
If you choose option 4: You can select to print the pattern only 3 times on the hoop or how many times you wish. To fill the LEDS that are turned off use the Numeric Keypad to choose a color.
Only your Pattern will Play, the color you chose will remain in place, creating a marquee type of pattern.
Important: This mode does not reset by itself so make sure option 1 is selected to have patterns display on entire hoop.
Option 1 is indicated by 3 white LEDS next to the MODE Leds.