1. Select the Dashboard display
2. Select Powercraft
Creating a Power Craft Log
1. Select +New
2. At the next screen select from the following options
- Select either Operational or Training
- Air Temperature, Water Temperature & Wind Speed and Wind Direct will pre-fill using data from the Bureau of Meteorology (BOM)
- Select drop-down options for Sea Conditions and Wave Height
- Select Create Log
3. The new log will display with a Status of Draft. The system will take you to the Members Screen.
4. In the Members Area you will be prompted to add at least one driver and one crew for the log.
Click the Arrow Down next to the driver
Click on +Add Driver
5 A list of available drivers will display and the option to add a Visitor Driver (Top right corner)
Select the driver from the list and click Done
Add the hours completed by the Driver > Add additional Drivers if needed
Add a Crew Member.
6. Click Gear and then click Assign Gear
You will be prompted to select an IRB, make your selection and click Done
You will then be prompted to do your Pre-Check, you can complete this by clicking on the red X underneath ‘Pre Check’
Complete each Pre-Check as required by clicking on the PASS button for each pre-check that has been performed for your IRB.
Click ‘SAVE’.
You will then be prompted to select an IRB Motor, make your selection and click Done and continue with the Motor Pre-Check.
Once you have completed the Powercraft Status, Members and Gear Sections you will be prompted to change the log from Draft to Open.
A message will appear ‘All minimum requirements met. You can now change the log status to OPEN’.
Click ‘Change’ and the system will automatically update your log to the status of Open.
If you wish to take a photo and add this to your powercraft log go to the Status section and at the bottom of the form and there will be a camera icon.
Click on the camera icon to take picture (ie: picture of the conditions or the IRB Gear).
You can add a comment via the Status Page.
If you wish to email an Excel or PDF version of your powercraft log to your email address (email address that is attached to your Surfguard Membership File, go to the Status section. At the bottom of the form their is a red SEND button. Click the Send button.
Need more help with this?
Don’t hesitate to contact us here.