This document will provide explanations for the offline installation of PostgreSQL 10 on Linux – including replication configuration with automatic failover (using REPMGR). Please find the attached zip file (called “HA DB rpms.zip”) which contains all of the RPMs needed. Following is a short summary followed by a detailed procedure.

Steps Summary

  1. Extract & Install (on all nodes)
  2. Configure PostgreSQL & allow ports (on all nodes)
  3. Set up REPMGR
  4. Configure REPMGR – On the primary node
  5. Configure REPMGR – On any replica node
  6. Pre-failover Actions

Need more help with this?
Click here to open a Support ticket

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.