This needs to be carried out on the primary (master) node. Note that the commands executed are different in the primary node than the secondary.

  1. Configure the REPMGR configuration file (default located on “/etc/repmgr/10/repmgr.conf”) by changing the configuration as follows:
    (Remove comments # in the file)
node_id = 1
node_name = 'N1'
conninfo = 'host=<LOCAL IP> port=5432 user=repuser dbname=postgres password=<POSTGRES USER PASSWORD>'
replication_type = 'physical'
use_replication_slots = yes
pg_bindir = '/usr/pgsql-10/bin'
failover = 'automatic'  
data_directory = '/var/lib/pgsql/10/data'
promote_command = '/usr/pgsql-10/bin/repmgr standby promote -f /etc/repmgr/10/repmgr.conf --log-to-file'
follow_command = '/usr/pgsql-10/bin/repmgr standby follow -f /etc/repmgr/10/repmgr.conf --log-to-file --upstream-node-id=%n'
monitoring_history = yes
monitor_interval_secs = 10
service_start_command = 'sudo systemctl start postgresql-10'
service_stop_command = 'sudo systemctl stop postgresql-10'
service_restart_command = 'sudo systemctl restart postgresql-10'
service_reload_command = 'sudo systemctl reload postgresql-10'

Note that you can find the the configuration parameters description here:

  1. After changing the above configurations, the linux postgres user needs to initialize the primary node.
    1. su - postgres
    2. /usr/pgsql-10/bin/repmgr -f /etc/repmgr/10/repmgr.conf primary register
    3. Make sure that the primary was registered by running the following command:
      /usr/pgsql-10/bin/repmgr -f /etc/repmgr/10/repmgr.conf cluster show

Need more help with this?
Click here to open a Support ticket

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.