This document provides instructions to install the SemaConnect charger and should not be used for any other product. This product must be installed in accordance with the National Electrical Code (NEC), the Canadian Electrical Code (CEC), or any applicable local code.

Review this manual and consult a licensed contractor and/or electrician before installation to ensure compliance with local building practices, climate conditions, safety standards, and state and local codes.

There are 2 options for installation:

  1. Option 1: Use the NEMA plug included with the charger
  2. Option 2: Hardwired charger should be installed by a licensed contractor/ electrician and inspected by a qualified installer prior to initial use. Under no circumstances will compliance with the information in this manual relieve the user of responsibility to comply with all applicable codes and safety standards.
    This document describes the most common installation and mounting methods. Contact SemaConnect where it is not possible to perform an installation using the procedures provided in this document.
    SemaConnect is not responsible for damages that may occur or result from installations that are not described in this document. Please read and understand instructions before attempting to unpack, install, operate, or maintain this equipment. Study the charger and its mechanism carefully before attempting to operate it on an energized circuit. All possible contingencies that may arise during installation, operation, or maintenance, and all details and variations of this equipment do not purport to be covered by these instructions. If further information is desired by the purchaser regarding a particular installation, operation, or maintenance of particular equipment, contact SemaConnect.

General
The SemaConnect charger is grounded through a dedicated conductor to the ground connection at the power distribution panel.

Statements
Reasonable effort has been made to ensure that the specifications and other information in this manual are accurate and complete at the time of publication. However, specifications and other information in this manual are subject to change at any time without prior notice. Use of the SemaConnect charger in a manner not intended or any modification not approved by the manufacturer will void the limited warranty. Other than the limited warranty, SemaConnect products are provided “AS IS,” and SemaConnect and its distributors expressly disclaim all implied warranties, including any warranty of design, merchantability, and fitness for a particular purposes and non-infringement, to the maximum extent permitted by law.

IN NO EVENT SHALL SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL, PUNITIVE, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST PROFITS, LOST DATA, LOSS OF USE, COST OF COVER, OR LOSS OR DAMAGE TO THE SEMACONNECT™ CHARGER ARISING OUT OF OR RELATING TO THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. The equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

For questions, please contact SemaConnect:

  • Email: support@semaconnect.com
  • Phone: 1-877-794-2214 Ext: 105

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment