Module Configuration Screen Tabs / Zones /

	ConveyLinx ERSC ✅	ConveyLinx-Ai 24V ✅	ConveyLinx-Ai 48V ✅
	ConveyLinx-ECO ✅	ZPA Mode ✅	PLC I/O Mode ❌

The Run After time value is used by the logic for normal zone discharge. This is the amount of time the zone’s MDR will continue run after its photo-sensor has been clear when discharging to the next downstream zone.

*Please note that Run After does not affect throughput rate. A longer Run After time will not prevent an upstream item from entering the zone.

Learn More About Run After Settings

Learn More About Induct Settings