Module Configuration Tabs / Sensors / ConveyLinx-ECO Family /

	ConveyLinx ERSC ❌	ConveyLinx-Ai 24V ❌	ConveyLinx-Ai 48V ❌
	ConveyLinx-ECO ✅	ZPA Mode ✅	PLC I/O Mode ❌

By default and without any intervention, the most upstream zone will never turn on to accept new product. To cause the most upstream zone to run to accept an item with a wired signal, you need to utilize the Aux I/O Pin 2 for the upstream zone as a Wake-up input.

*More information on upstream behavior can be found in the Upstream Interlock topic

Assuming the most upstream zone is connected to the left side of the module; we set the Left Pin 2 to Wake up from the drop-down box and make sure we click the UP arrow to indicate that the Left Pin 2 signal is to be associated with the Upstream Zone. When the Left Pin 2 signal is energized, the upstream zone will run to accept an item

*Please note that as long as the most upstream zone is empty and you continue to apply the Wake up(DI) signal on the most upstream zone AUX input, the most upstream zone will continue to run as long as the signal is on. If you select Wake up with timeout (DI) from the dropdown, if the AUX signal is on for 8 seconds with no arrival in the zone, the motor will automatically shut off. To re-initialize the wake up function, the AUX signal must turn off and then back on again.