Module Configuration Screen Tabs /

	ConveyLinx ERSC ✅	ConveyLinx-Ai 24V ✅	ConveyLinx-Ai 48V ✅
	ConveyLinx-ECO ✅	ZPA Mode ❌	PLC I/O Mode ❌

From the Configuration tab you can place the ConveyLinxモジュール into Hardware Controlled Mode which disables all ZPA Mode and PLC I/O Mode functionality and allows the Left and Right side motors to be controlled independently with hardwired signals to their respective Left and Right M8 Sensor Ports or RJ-12 Control Ports.

* Motor speed, accel/decel, brake mode, etc. settings will be the last configured from EasyRoll+

*Please note that after configuration from EasyRoll+, Ethernet network connection is not required for Hardware Controlled Mode operation. However, if an Ethernet network connection is maintained, a remote PLC can connect to the ConveyLinxモジュール and read status inputs. While in Hardware Mode, the ConveyLinxモジュール will ignore any command inputs coming from a connected PLC.

Learn more for each model type

ConveyLinx-ERSC

ConveyLinx-Ai2/Ai3