Module Configuration Tabs / Sensors / ConveyLinx-Ai Family /

	ConveyLinx ERSC ❌	ConveyLinx-Ai 24V ✅	ConveyLinx-Ai 48V ✅
	ConveyLinx-ECO ❌	ZPA Mode ✅	PLC I/O Mode ❌

Please note that by default and without any intervention, the most downstream zone will always try to discharge product. To control this, you need to utilize the Aux I/O Pin 2 signal for the most downstream zone as an Accumulate input.

*More information on downstream behavior can be found in the Downstream Interlock topic

Assuming the most downstream zone is connected to the right side of the module; we set the Right Aux I/O Pin 2 to Accumulate from the drop-down box and make sure we click the “DOWN” arrow to indicate that the Right Pin 2 signal is to be associated with the Downstream Zone. When the Right Pin 2 signal is energized, the downstream zone will stop when an item arrives on its sensor